Gauge accuracy is dependent on the correct wiring order and quality connections.The original gauge wire harness was incorrectly designed and current does not flow in proper order.The Gauge Connect System replaces the obsolete wire harness with a printed circuit board that corrects the wiring order and has modern wire and terminals. This also reduces the number of wires and connections to the gauges.Simple installation, uses wire ties to mount the board.
Replace this crude assembly
The factory resistor is for the alternator and operates warm to hot. This causes the wires to oxidize and weakens the strength of the wire. Eventually the wire breaks just from the vibration of driving. Resoldering the wire doesn’t last long since the wire is now closer to the heat of the resistor.
Our solution for this resistor is this modern assembly of multiple resistors to spread the heat and terminals for the lamp socket. NO soldering or tools are needed to install and it’s a rugged long lasting construction.This solution also allows our LED Gauge Lamp light to be used for the “GEN” light indicator which will not burn-out !
Generator Light ResistorPart # GLR, Price $29.00
>The Sipea Relay Module is specifically designed to replace the Sipea 5170 relay internal coil and contacts.>The Sipea Relay Module 5170 replaces the following Sipea relays types; 5170, 5220, 5230, 5610, 7810> Designed to support higher current than the original relay. Rated at 30 Amps> Retain the factory appearance with high reliability and extreme life expectancy.> The design is modern construction and components for extreme long life> The terminal tabs are in the same location and labeled the same as the factory relay.> The Sipea Relay Module is entirely electronic so there are no moving parts to arc or fail.