The Reverse LED array conversion has 2 integrated sets of high power LEDs. An array of white LEDs and red LEDs. This allows greater use of the tail light area for more functions. > The Reverse LED array converts the reverse section of the tail lights to brake lights. The high power red LED array illuminates the clear reverse light lens when the brakes are applied. > Placing the shifter in reverse gear activates the high power white LED array illuminate the lens and the red LEDs are disabled. > LED's illuminate 0.20 seconds faster than incandescent bulbs. (a vehicle moving at a speed of 65 miles per hour will travel a distance of 19 feet in 0.20 seconds) > Easy installation, remove rear tail light lens and reverse bulb, disconnect wires to the lamp socket, install LED array and replace the lens. > Very low power consumption, very long life in excess of 50,000 hours. Rugged LED technology, no filament to break. > Red LED array in the reverse light section add to the brake light area to improve visibility for other drivers ... safer operation for the owner. > Electronically controlled constant brightness, even at idle engine speed. > Simple wiring, matching color wires to the factory harness. > White painted LED reflector replaces the factory silver plated plastic reflector. > Rusty or inoperative lamp sockets are not used, LED arrays connect directly to the Pantera harness connector. > Modern appearance without distorting the original design. LED Reverse Conversion Part # RVSLED-01 Price - $49.00 USD per pair  LED Reverse Light Actual images used in this demo. The only manufacturer of electronic technology designed exclusively for the de Tomaso Pantera PRODUCTS