All products are designed on multiple CAD platforms with mechanical and electronic cross compatibility, this allows fast time to market and products with superior fit and function. Product Development Transaxle Gear Indicator - Indicator displays gear ratio 1 through 5. Neutral gate and Reverse is displayed as "-". Transaxle Encoder - Gear ratio selection and gear changes are detected by the transaxle encoder and decoded to the dash display. Power Deck Lid Lift - Electronically controlled power deck lid lift system that maintains original factory appearance, 5 second open and close rates. Dual Tandem Brake Master Cylinder - Lightweight with mechanical balance adjustment (no hydraulic reducer) that will exact fit on the OE factory brake booster. Utilizes top of the line series 75 Tilton master cylinders. PRODUCTS The only manufacturer of electronic technology designed exclusively for the de Tomaso Pantera Replacement Wire Harness - A wire harness with the factory appearance yet improved with modern insulation for a compact and lighter harness. A re-designed wire layout for improved current distribution and cooler operation. Air Conditioner Controller - The A/C controller will include visual indicators of the status of the A/C condenser fan control, A/C compressor control and horn switch. There will be an audio type tone to replace the "key reminder buzzer". There will be a unique speed ramping for the A/C condenser fan motor which will reduce the very high current at start up. This high current demand is on the very long wire that extends from the relay box to the A/C condenser fan. (safety issue) The A/C condenser fan will also have an extended operation timer to cool the condenser after the A/C thermostat has turned off the compressor. This will also stop excessive stopping and starting of the A/C condenser fan motor which shortens motor life. There will be a location to plug either Pantera-Electronics turn signal flasher (3 or 4 terminal) into the A/C Controller board depending on which flasher the Pantera is wired. The A/C Controller will be much smaller and lighter than the factory relay plate assembly, so that it can be mounted without the box. (if desired)